How to Fit a Brass Angled Tap Protector to Your Tap

By Buy Hoselink Products Australia | Garden Watering System ... | Published: 2026-11-03

Category: Guides pratiques

Fit a brass angled tap protector in five steps to stop hose kinks and strain on low or tight outdoor taps. Includes a leak-check checkpoint and common mistakes.

Quick answer

Screw the Brass Angled Tap Protector onto your outdoor tap by hand, then tighten it gently with a cloth-wrapped spanner and check for leaks before connecting your hose. The angled outlet lets the hose run diagonally away from the tap, which reduces strain when the tap sits close to the ground or in a tight space.

Why an angled outlet helps on low or cramped taps

A standard straight connection forces the hose to bend sharply where it meets the tap. On a tap installed close to the ground or tucked behind plants, that bend puts constant sideways load on the fitting and the tap body. An angled outlet redirects the hose diagonally, so the first bend happens in the hose rather than at the connection point.

This is a mechanical fix, not a flow-control device. It does not change water pressure or let you adjust flow, so if you need to throttle the hose, add a separate flow-control connector downstream.

When a straight connector is the better choice

If your tap has plenty of clearance below and in front, a straight tap-to-hose connector is simpler and less likely to snag on nearby objects. The angled design earns its place mainly where a straight connector would force the hose to kink or where the tap is hard to reach. Check the space around your tap before buying: the angled body projects to the side as well as down.

Fitting steps

1. Isolate the water and clear the tap: Turn off the tap fully and remove any existing hose or connector. Wipe the tap thread with a cloth so grit and old sealant tape do not get trapped in the new joint. Check the thread for cross-threading or damage before you start; a damaged thread will leak no matter how well you tighten.
2. Fit or refresh the sealing washer: Check that the protector has a sealing washer in place at the tap end. If you are reusing an old washer, replace it if it is flattened or cracked. A missing or hardened washer is the most common cause of a drip at the tap joint.
3. Screw the protector on by hand: Thread the protector onto the tap by hand, turning it clockwise until it seats. Keep the angled outlet pointing toward the direction your hose will run. Stop at the first sign of resistance; forcing a cross-thread damages both the protector and the tap.
4. Tighten gently with a spanner: Give the protector a small final nip with a spanner wrapped in cloth to protect the brass finish. A quarter turn past hand-tight is usually enough. Over-tightening crushes the washer and can split the tap body; firm is enough.
5. Run water and check the joint: Turn the tap on at normal pressure and watch the joint for a few seconds. If water seeps out, turn off, tighten slightly, and retest. Dry the joint first so any new drip is easy to see.
6. Connect the hose and test the run: Attach your hose to the angled outlet and pull the hose gently in the direction it will run. Confirm the hose leaves the tap without a sharp bend or pulling on the fitting. If the hose still kinks, reposition the angled outlet or add a short leader length of hose before the first bend.

Product facts

Brass Angled Tap Protector: Crafted from premium-quality brass and designed with an angled outlet for taps installed close to the ground or in tight spaces. Brass resists the wear of repeated hose connections, and the angled outlet reduces the sharp bend that strains both hose and tap.
Brass Angled Tap Protector