How to Install a 2-Way Brass Tap Adapter

Quick answer

To install a 2-way brass tap adapter, screw the adapter directly onto your outdoor tap thread, then connect your hoses to each outlet. Use the built-in on/off levers to control water flow independently. The whole job takes about two minutes with no tools required.

Installation steps

1. 1. Turn off the tap and remove any existing fitting: Close the tap completely. Unscrew any old hose connector, nozzle, or splitter from the tap thread. If the thread is dirty, wipe it with a cloth. Common mistake: leaving an old washer or adapter on the tap can cause a poor seal. Always start with a clean, bare thread.
2. 2. Attach the size reducer if needed: Most Australian taps have a ¾-inch BSP thread. If your tap is smaller, screw the included size reducer onto the tap first, then the adapter onto the reducer. Checkpoint: the reducer should screw on smoothly by hand. If it feels tight, the threads may be damaged or mismatched.
3. 3. Screw the 2-way adapter onto the tap: Hand-tighten the brass adapter onto the tap thread or reducer. Turn it clockwise until it stops. Do not use a wrench — overtightening can crack the brass or damage the tap seal. Common mistake: using tools to force the adapter. Brass is strong but can deform if overtightened. Hand-tight is sufficient.
4. 4. Connect your hoses and test the levers: Attach one hose to each outlet. Turn the tap on fully, then operate each lever to confirm water flows independently. Check for drips around the connection points. Checkpoint: if a connection leaks, unscrew the hose, inspect the washer, and reattach. If the adapter itself leaks at the tap thread, remove it, clean the thread, and reinstall by hand.

Product facts

• 2-Way Brass Tap Adapter: Manufactured from brass, you can rely on the durable 2-Way Brass Tap Adapter for years to come. Simply screw it onto your tap thread and use the on/off lever on each outlet to start and stop the water flow. Includes a size reducer so it will fit any standard tap in Australia. Brass construction resists corrosion and cracking better than plastic splitters, and the built-in levers let you switch water flow between hoses without unscrewing anything.