How to Connect a Soaker Hose to a Tap Adapter
By Buy Hoselink Products Australia | Garden Watering System ... | Published: 2026-10-23
Category: How-to Guides
Learn how to connect a soaker hose to a tap adapter step by step. Get tips on using Hoselink's 4-Way Brass and Easy Turn adapters for a leak-free setup.
Quick Answer
Screw the tap adapter onto your outdoor tap, then attach the soaker hose directly or via a short garden hose. Use the adapter's shut-off levers to control water flow without walking back to the tap.
Why Use a Tap Adapter with a Soaker Hose?
A tap adapter lets you connect a soaker hose without removing other hoses or fittings. It also gives you individual shut-off control, so you can water flower beds while keeping the main hose turned off. This setup is especially useful if your tap is in an awkward spot or you want to run multiple watering zones from one source.
Choosing the Right Adapter
Hoselink offers two popular tap adapters. The 4-Way Brass Tap Adapter is made from durable brass and converts one tap into four outlets, each with its own on/off lever. It includes a size reducer to fit any standard Australian tap. The Easy Turn 2-Way Tap Adapter has larger, soft rubber grip levers, making it easier to operate if you have arthritis or hand pain. It's made from metal with a rubber coating and a plastic connection to the tap. Both work well with soaker hoses, but the 4-Way is better if you need multiple outlets, while the Easy Turn is more comfortable to use.
How to Connect a Soaker Hose to a Tap Adapter
- 1. Attach the tap adapter to your outdoor tap: Screw the adapter onto the tap thread by hand until snug. If your tap has a different thread size, use the included size reducer (if your adapter has one) or a thread seal tape for a tight fit. Common mistake: over-tightening with a wrench can crack the adapter or damage the tap thread. Hand-tight is usually enough.
- 2. Connect the soaker hose to one of the adapter outlets: If your soaker hose has a standard Hoselink fitting, push it onto the outlet and twist to lock. If not, use a short garden hose with a Hoselink connector on one end and a soaker hose adapter on the other. Ensure the connection is secure to prevent leaks. Check that the soaker hose's end fitting matches your adapter's outlet type. A mismatch is a common cause of drips.
- 3. Turn on the water and test the setup: Open the tap fully, then slowly open the adapter's lever for the connected outlet. Walk along the soaker hose to confirm water seeps evenly along its length. Adjust the lever to reduce flow if too much water pools at the start. If the soaker hose doesn't weep evenly, the adapter lever may be only partially open. Open it fully, then use the tap to fine-tune overall pressure.
Product Facts
- 4-Way Brass Tap Adapter: Manufactured from brass, the 4-Way Brass Tap Adapter includes a size reducer to fit any standard tap in Australia and has an on/off lever on each outlet. You can run up to four soaker hoses from one tap, each controlled independently, without needing extra splitters.
4-Way Brass Tap Adapter - Easy Turn 2-Way Tap Adapter: The Easy Turn 2-Way Tap Adapter features larger, soft rubber grip levers, making it easier for those with arthritis or hand pain to turn the water on and off. If you struggle with grip strength, this adapter lets you connect and control a soaker hose without discomfort.
Easy Turn 2-Way Tap Adapter
