What the T Joint Does in Your Misting Setup
A misting system T joint is a simple but useful spare part that lets you branch your existing misting line in a second direction. Instead of running a single straight hose, you insert the T joint between two hose ends, and the third outlet points your misting line toward a new area.
This is handy when you want to cool two sides of a patio, reach plants on both sides of a path, or extend coverage around a corner without running a single long loop. The Hoselink Misting System T Joint is designed as an individual spare part, so you add it exactly where you need it.
T Joint at a Glance
- Misting System 'T' Joint: Individual Spare Part for Hoselink's Misting System. Used with the hose line on each end to extend the misting system in a second direction. This confirms the T joint is a branch piece, not a repair connector. You need it when your cooling setup demands two separate misting lines from one supply.

Misting System 'T' Joint
How to Install the T Joint
Before you start, make sure the water supply is turned off and the misting line is depressurized. The T joint fits into standard Hoselink misting hose, so no extra adapters are needed for the connection itself.
- Cut or separate the hose where you want the branch: Choose a spot along your existing misting line where you want the new direction to begin. Cut the hose cleanly or separate an existing connection. You will insert the T joint between the two ends.
- Attach the T joint to both sides of the cut hose: Push one end of the hose onto one side of the T joint, and the other hose end onto the opposite side. The T joint has three openings: two in line for the main hose, and one perpendicular for the new branch.
- Connect the new branch line: Attach a length of misting hose to the third outlet of the T joint. This hose will run to the area you want to cool. You can add misting nozzles, clips, or other fittings along this branch as needed.
- Block off the end of the new branch: The supplied evidence notes that you will require a second Misting System Stop Mist Valve to block off the additional line of hose. Without it, water will spray from the open end instead of through the misting nozzles.
A Realistic Note Before You Buy
The T joint only provides the branch connection. It does not include the stop valve needed to seal the end of the new line. Check that you have or order a separate Misting System Stop Mist Valve for each additional branch you create. Also, the T joint is a spare part, so it comes without instructions or additional fittings. Plan your branch length and nozzle placement ahead of time to avoid cutting hose too short.

